Rough Country 75134-15 - Manual (Page 5)

PowerBoard ® – Installation Instructions
Rev. N 0713 75134 pg. 5
Pull back the carpet and pull the trigger wires
through the grommet. Seal the holes in the grommet
with silicone sealant.
Access Trigger Wire
The trigger wires are color coded to match the factory door ajar wires. Use the Posi-Taps to connect the
trigger wires to the matching door ajar wires.
DRIVER SIDE
Front Driver Side: Dark Green with Purple stripe. Avoid lighter green wires as these will not work.
Rear Driver Side: Dark Green. Avoid lighter green wires as these will not work.
REGULAR CAB / SUPER CAB: These models do not have rear door ajar wires. Connect this wire to
the constant ground wire (Purple with Black Stripe).
PASSENGER SIDE
Front Passenger Side: White wire found just below fl at loom as shown.
Rear Passenger Side: Yellow. The correct yellow wire goes to the back door. Pull up on the yellow wire
that lieads to the back and does not cross over to the driver’s side at the junction. There will be move-
ment of the correct wire near where the trigger wires connect.
REGULAR CAB / SUPER CAB: These models do not have rear door ajar wires. Connect this wire to
the constant ground wire (Purple with Black Stripe).
If you can not fi nd the wire with the correct color you will need to install the motor (Step 13) and test each
individual wire until you fi nd the one that functions correctly.
Wiring
Grommet
Posi-Tap™ Instructions
Insert Tighten
Strip 3/8" Insert and
Tighten
Flat Loom
(under carpet)
White Wire
Trigger
Wires
Occasionally the actual wire color may be
different than stated here. You will need to
install the motor and test each wire until you fi nd the
wire that functions correctly.