Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Intake- Ram-Air Intake system '03-07 F-250-350-450 pickup User Manual
Page 10
7.
Remove the front air cover by
withdrawing and lifting out of engine
bay.
8.
Remove the rear air cover.
Note be careful when handling the
rear air cover the MAF/IAT sensor is
attached and will be reused.
9.
Remove the Torx (T-20), MAF
sensor screws using the supplied
Banks Torx tool bit. See Figure 6.
10.
carefully remove the MAF/IAT
sensor and set aside.
11.
Locate the supplied Banks MAF
sensor gasket or Banks IAT sensor
grommet and the Banks Intake tube
from your kit. Install the supplied
gasket or grommet as shown in
Figure 7A and Figure 7B.
12.
Install the MAF sensor to the
Banks intake tube using the supplied
screws.
Note: Do not over tighten the screws.
Or, install the IAT sensor into the
grommet by inserting in the sensor
until it seats flush on the grommet.
13.
Locate the previously removed
factory rear air inlet cover and remove
the rubber grommet used to secure
the air filter minder.
14.
Install the rubber grommet to the
Banks Intake tube.
15.
In the engine compartment
towards the front-top radiator brace,
on the (drivers-side), locate the long
radiator/intercooler fastener bolt. See
Figure 8.
16.
Remove the wire harness loom tie
down from the long bolt.
17.
Remove the long bolt using a
10mm wrench.
18.
Remove the wire harness loom
fastener from the wire harness.
Figure 5
10
96463 v.7.0