Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Intake- Ram-Air Intake system '03-07 F-250-350-450 pickup User Manual
Page 8
Use the Bill of Materials chart and
the General Assembly Drawing to
reference component nomenclature
and location. Use caution when
working in the engine compartment.
Make sure the engine has been OFF
for several hours and cool.
You are about to install the Banks
Ram-Air Intake System. Read and
follow all steps before working on the
vehicle. Some components from the
stock air intake system will remain
in service. Take care when removing
stock air intake components to not
damage them.
1.
Remove the auxiliary air inlet hose
located on the front of the factory air
filter cover. Use pliers to remove the
auxiliary air inlet hose clamp and set
aside. See Figure 2.
2.
Unfasten the four tension clamps
located on the top of the factory air
box.
3.
Loosen the hose clamp on the air
inlet bellows located next to the Mass
Air Flow (MAF) sensor. See Figure 3.
Note: Some vehicles do not have a
MAF sensor but instead utilize an
Intake Air Temperature (IAT) sensor.
Both sensor types are installed in the
same location on the intake tube.
4.
Locate the MAF/IAT connector,
press the release tab and carefully
remove the MAF/IAT connector and
set aside.
5.
Remove the Air Filter Minder by
gently twisting and pulling out of the
rubber grommet. See Figure 4.
Note: Leave the Air Filter Minder
connected to the attached electrical
connector and set aside.
6.
Separate front and rear air filter
covers from center filter element.
Remove the center filter element and
set aside. See Figure 5.
Section 2
RAM-AIR INSTALLATION
Figure 2
8
96463 v.7.0