Banks Power Chevy_GMC Trucks: Duramax LLY (Diesel ’04 - 05 6.6L) Speed Control- Banks Brake w_ Switch - Manual (Page 12)

12
97245 v.2.0
NOTE: make sure the fuse box cover
is clean and free of any oil residue and
contaminates. Clean fuse box cover
with a non-oil based solvent such as
Acetone, Mineral Spirits, Denatured
Alcohol or Lacquer Thinner. Read and
follow the manufactures operation
instruction for non-oil based solvent
cleanser.
If vehicle is equipped with a Banks
Tuner, detach the Tuner from the top
of the fuse box cover and reattach
on the fuse box side or on top of the
fuse box along with the SpeedBrake.
See Figure 6 & 7. If placing the Tuner
on top of the fuse box along with
the SpeedBrake module there may
be some over hang from the tuner.
Secure the tuner so that it stays in
place. Use the supplied hook & loop
interlocking fasteners to make the
necessary adjustment to attach the
SpeedBrake to the top of the fuse box
cover and Banks Tuner to the fuse box
side or top.
WARNING: Make sure to place
the SpeedBrake Module as shown
in Figure 8 to avoid a clearance
issue when closing the hood.
Mount the SpeedBrake Module
as close to the inside edge of the
fuse cover as possible.
14.
Insert the SpeedBrake 20-pin
Module connector on the wire harness
to the SpeedBrake Module. Using the
supplied cable ties, secure the wire
harness away from any heat sources
(i.e. Driver side exhaust manifold) or
moving components.
15.
Locate the Banks OBD II Interface
Cable in your kit. This cable has
three connection points. Connect the
RED OBD II connector on the Banks
interface cable to the vehicle OBD II
connector. Use a cable tie as shown in
Figure 9 to secure the Banks interface
cable to the vehicle OBD II connector.
Figure 8