Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit, F-250_F-350 '03-07 Pickup Trucks and Excursions - Manual (Page 10)

A) Using a pry bar, completely remove
the rubber hanger from the front muffler
hanger pin. Remove the two (2) factory
nuts on the front muffler hanger pin
from the frame rail and remove the
hanger pin from the vehicle. Retain
the rubber hanger for re-assembly.
B) Install the supplied hanger pin to the
vehicle frame about 10-16” to the rear
of the original muffler hanger location
(see Figure 3). Install the supplied bolts
and washers into the hanger plate and
through the frame. Install the supplied
nuts and torque to 20 ft-lbs (27 N*m).
c) Reinstall the rubber hanger onto the
mounted hanger pin assembly.
11.
Install the single pin front hanger
clamp onto the rear of the intermediate
pipe with the hanger pin on the inside
facing the muffler. Insert the hanger
pin into the vehicle’s rubber grommet.
Install the inlet of the Banks Monster
muffler to the intermediate pipe.
12.
For F-series Trucks, install the
dual pin rear hanger clamp onto the
outlet of the Monster muffler with the
hanger pins on the inside, facing the
muffler.
For Excursions, install the rear hanger
clamp with the pins facing to the
rear of the vehicle. Insert the two
hanger pins into the vehicle’s rubber
grommets.
13.
Route the tailpipe over the rear
axle housing and into the muffler outlet.
Install the tailpipe hanger pin into the
corresponding rubber hanger. Loosely
snug the 4” hanger clamp onto the
muffler outlet.
Figure 4
10
94440 v.13.0