Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit, F-250_F-350 '03-07 Pickup Trucks and Excursions User Manual
Page 11
14.
Install the 5” Monster tailpipe tip
on the exhaust. Keep the wrapping on
until installation is complete. The tip
should be rotated so the clamp nut and
drain hole are pointing down. Align the
end of the tip with the body line of the
truck.
15.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front and working your way back.
Torque the exhaust clamps evenly
to 35 ft-lbs (47 N*m). Make sure that
each slip is fully inserted (+/-
1
⁄
4
inch)
and that all mount hangers are in the
forward position (see Figure 4).
16.
Remove the protective covering
from the tailpipe tip.
CAUTION: The protective covering
may ignite and burn if not removed
prior to running the engine.
17.
Your system includes two “Banks
Power” logos designed to complement
the Ford badging on your truck. Use the
provided measurements (see Figure
5) to position the logos for a clean
factory look.
18.
Re-connect negative battery
cable(s). Start the engine and listen
for exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack-welding slip connections
to prevent disengagement is
recommended. Your Banks Monster
Exhaust installation is now complete.
Figure 5
96440 v.13.0
11