Banks Power Cummins Motorhomes: (Diesel ’93 - 98 B5.9L & C8.3L) PowerPack & Stinger systems w_Twin Ram Manifold 5.9L, 190-210-230-hp rated - Manual (Page 9)

9 p.n. 96385
locate the cam plate cover on the injection
pump. see Figure 5. The cover is just
to the rear of the area where the six injector
pressure tubes connect to the pump body, and is
retained by four screws. clean any dirt, grease,
or foreign material from the cam plate cover,
especially in the area where the cam plate cover
flange contacts the main pump body, to prevent
contaminants from entering into the pump upon
disassembly.
use a sharp scribe to scribe a line in the
injector pump body along the outside edge
of the cam plate cover where the cover attaches
to the pump (along the upper edge of the cover, on
the side facing the engine). Then scribe another line
at a right angle across the first, from the pump body
onto the cover. These scribe lines are to enable you
to reinstall the cam plate cover in exactly the same
position. You may make any additional scribe lines
if you feel it may be helpful.
loosen and disconnect a rubber hose and
a plastic tube from a “tee” fitting located
in the air flow valve cover. This is a smaller cover
attached to the rear of the cam plate cover, with
four screws facing the rear of the engine.
The upper forward screw attaching the cam
plate cover to the fuel pump body has a
factory break-off tamper proof head. This screw
head must be modified to provide some means of
Figure 7
Figure 6
38.
39.
36.
37.