Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Exhaust- Monster Exhaust, Split-Dual, side exits '07-10 including Mega Cab User Manual
Page 11
96466 v.7.0
11
14.
Un-clip the axle vent hose outlet
attached to the bed near the spare
tire. Re-route the vent hose on top of
the fuel tank and attach to the bed. Zip
tie the vent hose and brake line to the
emergency brake cable, away from the
tailpipe.
15.
Adjust each of the pipes to
ensure that all of the hanger pins
are parallel with the frame-mounted
pins and fully inserted in the vehicle’s
rubber insulators.
16.
Be sure that the two (2) tailpipes
are completely engaged into the
Y-pipe. Rotate the tailpipe until the
hanger pins are parallel with the
frame-mounted pin.
Note: Recommended distance
between exhaust tip and body is a half
(
1
⁄
2
”) inch.
17.
Beginning with clamps closest
to the Diesel Particulate Filter, and
working your way back, align the
saddle clamps to on the radius of the
corresponding pipe slots. Torque the
nuts on each of the exhaust clamps to
35 ft-lb.
18.
Remove the protective covering
from the tailpipe tip.
CAUTION: the protective covering
may ignite and burn if not
removed prior to running the
engine.
19.
Your system includes two (2)
Banks power logos. The logos can
be mounted
1
⁄
2
” to 1” above the
“cummins Turbo Diesel” emblem on
the driver-side and passenger-side
front fenders.
20.
Re-connect battery terminals if
previously removed. Start the engine
and listen for exhaust leaks. Tighten
the exhaust clamps as necessary.
Whenever possible, tack weld slip
connections to prevent disengagement
is recommended.
21.
The Banks Monster Exhaust
installation is now complete.