Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) Programmer- Ottomind Programmer '99-07 Chevy-GMC 4.8L, 5.3L, 6.0L, 8.1L Trucks '01-07 Chevy-GMC 8.1L WorkHorse Class A Motor Home - Manual (Page 8)

The stock tune can be reinstalled at
any time by following the instructions
below. This feature will remove the
Banks OttoMind performance tune
and will reinstall the factory tune. The
Banks OttoMind performance tune
will be saved in the Banks OttoMind
programmer.
NOTE: It is recommended to return
to stock tune whenever the vehicle
goes in for service. This will allow
any reflashing of the ECM by the
dealership without affecting the Banks
OttoMind performance tune.
1.
Plug the OBD II connector from
your Banks OttoMind programmer
into the OBDII connection port of your
vehicle.
2.
Scroll to ‘Program’ in the main
menu screen and select it by scrolling
up or down until it is highlighted and
press the ‘ENT’ button.
3.
Using the keypad in the ‘PROGRAM’
screen, scroll up or down to highlight
the ‘Load Stock PROGRAM’ and press
the ‘ENT’ button. See Figure 7.
Section 3
RESTORING FACTORy TUNE
4.
Press the ‘ENT’ button to continue
restoring stock tune or ‘ESc’ button to
abort and go to the previous menu.
5.
Follow the on screen instructions
and turn the ignition key ON, but do
not start the engine, when prompted
by the programmer.
Warning: Unplugging
the Banks OttoMind
Programmer while
uploading or downloading
a program can damage
the vehicles ECM.
6.
The data downloading may take
a few minutes to complete. Once
the upload is complete you will be
instructed to turn key OFF and press
‘ENT’ as shown in Figure 8.
7.
The original factory stock tune
restoration is complete. You may
unplug the OttoMind programmer and
drive your vehicle.
-END, SEcTION 3-
8
96343 v.6.0