Banks Power Jeep Trucks: (Gas ’91 - 02 2.5L) Exhaust Monster, Single out the back, 2.5L I-4 (07-03 Wrangler (TJ)) 4.0L I-6 (1991-95 Wrangler (YJ), 1997-06 Wrangler (TJ), 2004-06 Wrangler Unlimited) - Manual (Page 2)

General Installation
Practices
1.
For ease of installation of your
Banks system, familiarize yourself with
the procedure by reading the entire
manual before starting work.
2.
The exploded view (Figure 1).
provides only general guidance. Refer
to each step and section diagram in
this manual for proper instruction.
3.
Throughout this manual, the
left side of the vehicle refers to the
driver’s side, and the right side to the
passenger’s side.
4.
Disconnect the ground cable from
the battery (or batteries, if there are
two) before beginning work.
5.
Route and tie wires and hoses a
minimum of 6” away from exhaust
heat, moving parts and sharp
edges. clearance of 8” or more is
recommended where possible.
6.
When raising the vehicle, support it
on properly weight-rated safety stands,
ramps or a commercial hoist. Follow
the manufacturer’s safety precautions.
Take care to balance the vehicle to
prevent it from slipping or falling. When
using ramps, be sure the front wheels
are centered squarely on the topsides;
put the transmission in park; set the
hand brake; and place blocks behind
the rear wheels.
Caution! Do not use floor jacks to
support the vehicle while working
under it. Do not raise the vehicle
onto concrete blocks, masonry
or any other item not intended
specifically for this use.
7.
During installation, keep the work
area clean. Do not allow anything to
be dropped into intake, exhaust, or
lubrication system components while
performing the installation, as foreign
objects will cause immediate engine
damage upon start-up.
Tools Required:
• 1 ⁄
4
” and 3 ⁄
8
” drive ratchets with inch
and metric sockets and 1 ⁄
4
” and 3 ⁄
8
”
drive extension
• Inch and metric combination or
open-end wrenches
• Standard screwdriver
• Standard and needle-nose pliers
• Clean shop towels or rags
Highly recommended tools and supplies:
• Inch-pound and foot-pound torque
wrenches
• Compressed air source and hose
• Air pressure regulator
• Penetrating oil or light lubricant
spray
• Reciprocating saw
2
96435 v.10.0