Banks Power Chevy_GMC Trucks: Gas ’99 - 14 4.3,4.8,5.3,6.0,6.2,8.1 Exhaust- Monster Exhaust, Single Passenger side exit '06 (6.0L 2500HD) - Manual (Page 6)

1.
Disconnect the negative (ground)
cable from the battery (if there is more
than one battery, disconnect both
negative cables). Secure the cable so
it cannot accidentally come in contact
with the post.
2.
Raise the vehicle and support it
securely with properly weight-rated
safety stands, ramps or a commercial
hoist. Take care to balance the vehicle
to prevent it from slipping or falling.
When using ramps, be sure the wheels
are centered squarely on the topsides.
Place the transmission in park
(automatic), set the parking brake and
securely block the wheels that are on
the ground.
CAUTION: DO NOT WORK UNDER
ANY VEHICLE SUPPORTED ONLY
BY A JACK. SEVERE INJURY MAY
RESULT.
3.
Using a reciprocating saw, cut the
two (2) intermediate pipes 13” front
of the muffler weld. Take time when
measuring and cutting the factory
intermediate pipes to ensure the
proper location and a straight cut.
Improper cut will result in poor fitment
of the Banks Monster exhaust system
(see Figure 2).
4.
Remove the rear muffler hanger
pin and tailpipe hanger pin from the
vehicle’s rubber hanger. Remove the
tailpipe, muffler and intermediate pipe
assembly from the vehicle.
NOTE: Spray lubricant may assist in
hanger pin removal. Rubber hangers
can also be removed from the vehicle
to assist in tailpipe / muffler removal.
5.
Install a three-inch (3”) clamp
on each previously cut factory
intermediate pipe outlets. Install
the Banks y-pipe onto the two (2)
previously cut pipe outlets. Be sure the
y-pipe jog is orientated with the jog
going up towards the cab. Install the
y-pipe hanger into the vehicle’s rubber
hanger. Lightly tighten the two (2)
three-inch clamps on the y-pipe inlet.
(see Figure 3).
NOTE: All clamps should be positioned
at the beginning of the slots (on the 1 ⁄
2
circle punch).
NOTE: Once the pipe / muffler has
been completely engaged in the slip
joint, mark the pipe with a scribe or
tape for reference when tightening the
clamps later in the installation. Mark
each slip joint in this fashion.
6.
Install a 3- 1 ⁄
2
” clamp onto the y-
pipe outlet.
7.
Install the Monster Muffler inlet
(Note the inlet labeling of the muffler)
onto the y-pipe outlet. Orient the
Monster logo such that is visible from
the passenger side and parallel with
the frame rail. Align the clamp onto
the muffler inlet (see Figure 3).
8.
Install the rear muffler hanger
clamp onto the Monster Muffler outlet.
Insert the hanger pin to into the
vehicles rubber hanger (see Figure 4).
9.
From the vehicle rear, route the
tailpipe over the rear end. Install the
tailpipe into the Banks Muffler outlet.
Start the tailpipe hanger pin into the
corresponding vehicle rubber hanger.
Lightly tighten the rear muffler hanger
clamp to secure the tailpipe.
10.
Adjust the tip about 1 ⁄
2
” under the
body panel, such that the tip position
is aesthetically pleasing.
11.
Adjust each of the pipes to ensure
that all of the hanger pins are parallel
with the frame mounted pins and that
the rubber hangers are all positioned
slightly forward (See Figure 5). This
allows the hangers to be properly
positioned once the exhaust reaches
operating temperature.
Monster Exhaust System Installation
6
96313 v.3.0