Banks Power Chevy_GMC Trucks: Gas ’99 - 14 4.3,4.8,5.3,6.0,6.2,8.1 Exhaust- Monster Exhaust, Single Passenger side exit '06 (6.0L 2500HD) - Manual (Page 8)

12.
With the exhaust positioned
properly, begin to evenly tighten the
clamps starting with the ones closest
to the front of the vehicle and working
your way back. Torque the exhaust
clamps evenly to 35 ft-lbs. Make sure
that each slip is fully inserted (+/- 1 ⁄
4
”).
13.
Remove the protective covering
from the tailpipe tip.
Caution: the protective covering
may ignite and burn if not removed
prior to running the engine.
14.
Your system includes two (2)
Banks Power logos designed to
complement the vehicle’s “2500 HD”
emblems on passenger and driver side
doors. The BanksPower decal can be
placed 1 ⁄
4
” above the emblems.
15.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended.
16.
The Banks Monster Exhaust
installation is now complete.
Y-PIPE
HANGER
FACTORY
INTERM PIPES
(PREVIOUSLY CUT)
3“ SADDLE
CLAMPS
BANKS
Y-PIPE
MONSTER MUFFLER
(NOTE
INLET LABEL)
3 1/2”
SADDLE
CLAMP
Figure 3
8
96313 v.3.0