Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Exhaust- Monster Exhaust, Single Passenger side exit, Dual-Tip '07-10 Including Mega Cab - Manual (Page 6)

6
96472 v.5.0
Figure 2
Cut line
See Table 1 for cutting length
2007-2010 Dodge 6.7L Cummins
Wheel Base
2007-2009/ 2010
cut this length from the Intermediate
Pipe. See Figure 2.
Mega cab/ Short Bed 160.5” No cut
Quad cab/ Long Bed 160.5”/ 169.5” No cut
Quad cab/ Short Bed 140.5”/ 149.5” 21.75”
Regular cab/ Long Bed 140.5” 21.75”
Table 1
10.
Install the supplied rubber
insulators onto the Banks hanger
brackets.
11.
Install the passenger-side tailpipe
into the intermediate pipe outlet.
Install the passenger-side tailpipe
hanger into the vehicle rubber
insulator.
12.
Un-clip the axle vent hose outlet
attached to the bed. Re-route the vent
hose on top of the fuel tank and attach
to the bed. Zip tie the vent hose and
brake line to the emergency brake
cable, away from the tailpipe.
13.
Adjust each of the pipes to
ensure that all of the hanger pins
are parallel with the frame-mounted
pins and fully inserted in the vehicle’s
rubber insulators. See Figure 3.
14.
Be sure that the tailpipe
is completely engaged into the
intermediate pipe. Rotate the tailpipe
until the hanger pins are parallel with
the frame-mounted pin.
Note: Recommended distance
between exhaust tip and body is a half
( 1 ⁄
2
”) inch.
15.
Install a supplied exhaust clamp
on the outlet of the tailpipe. Install the
Dual tailpipe tip on the tailpipe. Keep
the wrapping on until installation is
complete. Adjust the tip past the edge
of the body or where aesthetically
pleasing.
16.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
turbo and working your way back.
Evenly torque the exhaust clamps to
35 ft-lbs. Make sure that each slip is
fully inserted (+/- 1 ⁄
4
inch).