Banks Power Ford Trucks: (Gas ’99 - 11 6.8L V10; 6.2L V8) Exhaust- Monster Exhaust, Single Passenger side exit '05-06 Super Duty, 5.4L(V8) & 6.8L (V10) User Manual
Page 6
6
96444 v.2.0
8.
From the vehicle rear, route the
tailpipe over the rear end. Start the
tailpipe hanger pin into the
corresponding vehicle rubber hanger.
Install the tailpipe into the Banks
Muffler outlet. Lightly tighten the rear
muffler hanger clamp to secure the
tailpipe (see
Figure 3).
9.
Adjust the Tailpipe Tip 1” under the
rear fender such that the tip position is
aesthetically pleasing (see
Figure 3).
10.
With the exhaust positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front of the vehicle and working your
way back. Torque the exhaust clamps
evenly to 35 ft-lbs. Make sure that
each slip is fully inserted (+/-
1
⁄
4
").
All hanger pins should be facing
forward (see
Figure 4).
11.
Remove the protective covering
from the tailpipe tip.
Caution: the
protective covering may ignite and
burn if not removed prior to
running the engine.
12.
Your system includes two (2)
Banks Power logos designed to
complement the Ford Factory
emblems on the vehicles front doors.
13.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections to
prevent disengagement is
recommended. The Banks Monster
Exhaust installation is now complete.
REAR HANGER
BANKS
MONSTER TIP
3/4" - 1"
BANKS TAILPIPE
FORWARD
Figure 3