Banks Power GM Motorhomes: (Gas ’82 - 95 7.4L) PowerPack system (Carbureted, dual air pump) - Manual (Page 7)

connect the bulkhead fitting to the super-
scoop using the 4” diameter flex hose pro-
vided. cut the hose to the desired length using a
knife and diagonal cutting pliers. secure with two
no. 64 hose clamps. If your coach does not have
the factory air inlet hood bracket, but you do have
clearance to run the 4” flex hose forward of the
radiator, join the air filter snorkel to the ram-air
inductor with the two pieces of 4” diameter flex
duct provided. use the plastic bulkhead fitting as
a coupling between the hoses, and trim off the
curved section is desired. attach the flex hoses
with four no. 64 hose clamps. You may want to
tie the plastic bulkhead fitting down to keep it in
place. See Figure 8.
11.
P.n. 96341 7
raM-air
suPer-scooP
fiGure 7
fiGure 8