Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Exhaust- Monster Exhaust, Single out the back '03-04 - Manual (Page 9)

96422 v.5.0
9
the end of the tailpipe. For a dually,
the tip should be 3- 1 ⁄
2
” past the end
of the tailpipe or where aesthetically
pleasing.
14.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
turbo and working your way back.
Torque the V-band clamp to 80 in-lbs
(not ft-lbs). Evenly torque the exhaust
clamps to 35 ft-lbs. Torque the 7 ⁄
16
”
hardware to 48 ft-lbs. Make sure that
each slip is fully inserted (+/- 1 ⁄
4
inch)
and that all mount hangers are in the
forward position (see Figure 3).
15.
Remove the protective covering
from the tailpipe tip. Caution: The
protective covering may ignite
and burn if not removed prior to
running the engine.
16.
your system includes two (2)
Banks power logos. The logos can
be mounted 1 ⁄
2
” to 1” above the
“cummins Turbo Diesel” emblem on
the driver-side and passenger-side
front fenders.
17.
Re-connect battery terminals if
previously removed. Banks Monster
Exhaust installation is now complete.
Figure 3