Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Power Systems- PowerPack, Stinger-Plus, Stinger & Git-Kit '19991_2-2003 F-250 & F-350 Trucks and Excursions User Manual
Page 11
96336 v.10.0
11
For Excursions, install a 4” clamp onto
the muffler outlet.
For all applications, Install the Front
Monster tailpipe over the rear axle
housing and into the outlet of the
Monster muffler. Loosely tighten the
clamp on the muffler outlet to secure
the Front tailpipe. Insert a 4” clamp into
the outlet of the Front tailpipe. Install
the Rear tailpipe inlet into the Front
tailpipe outlet. Install the rear tailpipe
hanger into the corresponding rubber
hanger on the vehicle. Loosely tighten
the clamp to secure the Rear tailpipe
6.
Slip the 5” Monster tailpipe tip on
with the drain hole facing down and
Banks logo facing up. Keep the wrapping
on for now. For a Fleet-side truck the
5” tip should be hung 1” past the end of
the tailpipe. For a Dually, the tip should
be 3
1
⁄
2
” past the end of the tail pipe.
Snug up the clamp.
7.
Position all the exhaust components
such that all the hanger pins are parallel
with the frame pins and all exhaust
tubing is located properly. Lightly tighten
the clamps to maintain position. The
tailpipe tip should be positioned 1-1
1
⁄
2
”
below the bottom edge of the fender.
All hangers should be hanging slightly
forward to allow for heat expansion of
the exhaust tubing (see Figure 6).
8.
With everything positioned properly,
begin to tighten the clamps starting
with the ones closest to the turbo and
working your way back.
–END, SECTION 6–
Figure 4- Intermediate-Pipe Cut
Figure 6- Hanger Positioning