Cleaning and oiling the banks ram-air filter – Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) PowerPack & Stinger systems '05 & Later Class-A MH, W-24 chassis User Manual
Page 12
Notification
The Banks Ram-Air Filter comes
pre-oiled and no oiling is necessary
for initial installation. Use Banks
Ram-Air Filter cleaning system
(part#90094), available from Gale
Banks Engineering to service the
Air Filter. Follow the instructions
included with the cleaning system
to clean and re-oil your Banks Ram-
Air Fitler.
1.
PRE-CLEANING
Tap the element
to dislodge any
large embedded
dirt, then gently
brush with a soft
bristle brush.
NOTE: If complete
cleaning is not
practical at this time, reoil the element
and reinstall in your vehicle.
2.
SPRAy-ON CLEANING
Spray Banks air-filter cleaner liberally
onto the entire element and let soak
for 10 minutes.
PAN CLEANING
Large air-filter elements can be rolled
or soaked in a shallow pan of Banks
air-filter cleaner. Remove immediately
and let soak for approximately 10
minutes.
3.
CLEANING HINTS
Use only Banks air-filter cleaner. No
gasoline cleaning, No steam cleaning,
No caustic cleaning solutions, No
strong detergents, No high-pressure
car wash, No parts cleaning solvents.
Any of these Nos can cause harm to
the cotton filter media plus SHRINK
and HARDEN the rubber end caps.
4.
RINSE OFF
Rinse off the element with low-
pressure water. Tap water is okay.
Always flush from the clean side to
dirty side. This removes the dirt and
does not drive it into the filter.
Cleaning and Oiling the
Banks Ram-Air Filter
12
96438 v.2.0