Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Programmer- Ottomind Programmer '08 - Manual (Page 8)

8
96525 v.6.0
8.
In the ‘Tune Vehicle’ screen, select
‘Begin Program’ by highlighting it
and press the ‘ENTER’ button. This
will prepare Banks OttoMind for the
upload of your stock EcM. The Banks
OttoMind message center will display
the percentage of completion.
9.
Follow the on screen instructions
and turn the ignition key ‘ON’ when
prompted by the programmer, but do
not start the engine.
Note: Do not disconnect the
programmer while it is uploading or
downloading a program.
10.
The Banks OttoMind programmer
will begin to upload the Stock tune to
the Handheld and display percentage
of completion. After the completion of
the stock tune upload, Banks Ottomind
will download the tune to the EcM and
TcM. The Banks OttoMind message
center will display the percentage of
completion.
Note: the initial tune process may
take up to thirty minutes to complete.
11.
When the process is complete
the screen will display “Download
Complete, Turn Key OFF, Then Press
ENT.” See Figure 5.
12.
Your selected Tune is now in the
vehicle. You may drive it now. Please
unplug the Programmer before driving.
-END, SECTION 2
Figure 5