Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Programmer- Ottomind Programmer '08 User Manual
Page 9
96525 v.6.0
9
The stock tune can be reinstalled at
any time by following the instructions
below. This feature will remove the
installed Banks OttoMind tune and
will reinstall the factory tune. The
Banks OttoMind performance tune
will be saved in the Banks OttoMind
programmer.
Note: It is recommended to return
to stock tune whenever the vehicle
goes in for service. this will allow any
reflashing of the eCM by the dealership
without affecting the Banks ottoMind
performance tune.
1.
Plug the OBD II connector from your
Banks OttoMind programmer into the
OBDII connection port of your vehicle.
WARNING: Do not unplug the Banks
OttoMind Programmer while it is
restoring the factory tune.
2.
Scroll to ‘Program’ in the main
menu screen and select it by scrolling
up or down until it is highlighted and
press the ‘ENTER’ button.
3.
Using the keypad in the ‘Program’
screen, scroll up or down to highlight
the ‘Load Stock Program’ and press
the ‘ENTER’ button. See Figure 6.
4.
Press the ‘ENTER’ button to
continue restoring stock tune or ‘ESc’
button to abort and go to the previous
menu.
5.
Follow the on screen instructions
and turn the ignition key ON, but do
not start the engine, when prompted
by the programmer.
6.
The data downloading may take
a few minutes to complete. Once
the upload is complete you will be
instructed to turn key OFF and press
‘ENTER’ as shown in Figure 7.
7.
The original factory stock tune
restoration is complete. You may
unplug the OttoMind programmer and
drive your vehicle.
-END, SECTION 3-
Section 3
RESTORING FACTORy TuNE
Figure 7
Figure 6