Banks Power Jeep Trucks: (Gas ’07 - 11 3.8L) Exhaust- TorqueTubes system '07-09 3.8L Wrangler User Manual
Page 10
10
96495 v.5.0
ReLOCATe HeATeR HOSe BRACKeT
39.
Locate the stock heater hose
bracket fastened to the passenger side
valve cover stud. carefully remove
the bracket and unfasten it from both
water hoses. Drill a
1
⁄
4
” hole through
the battery tray as shown in Figure 5.
Using supplied
1
⁄
4
” screw and lock
nut relocate and fasten heater hose
bracket and position as shown in
Figure 6.
40.
Your system includes two
(2) Banks Power logos designed
to complement the vehicle’s
front fenders. See Figure 7 for
recommended logo placement.
41.
Your system also contains
a CARB eO label for emissions
purposes. This label should be placed
on the grill/radiator cross member
inside the engine compartment,
so that it is seen by an emissions
technician.
42.
The Banks TorqueTubes
installation is now complete.
Figure 6