Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- SpeedBrake '06-07 (iQ) For use with Banks iQ User Manual
Page 8
8
97239 v.4.0
7.
Remove the fuse box cover to
access the fuses on the electrical
center and set aside.
8.
Remove the fuse box assembly
cover by expanding the fuse box out
towards the engine side and lifting up,
exposing the fuse electrical center.
See figure 4.
9.
Push out on the tab closest to the
fender and the two locking tabs on the
side of the electrical center and lift up
to gain access to the c100 connector.
Disconnect the c100 connector. See
figure 5.
10.
Install the ground ring terminal
on the SpeedBrake wire harness onto
the bolt on the bottom of the electrical
center closest to the fire wall. See
figure 5.
11.
Insert the male c100 connector
on the SpeedBrake wire harness to the
female C100 factory connector. Insert
the female c100 connector on the
SpeedBrake wire harness to the male
C100 factory connector.
12.
Position the electrical center back
in place until the tabs snap into place.
Note: adjust the C100 connection
under the electrical center to have
sufficient room to lock the electrical
center back in place. Run the wire
harness out to the firewall side of the
fuse brace. See Figure 6.
Figure 5