Banks Power Dodge Trucks: (Diesel ’94 - 98 5.9L Cummins) Speed Control- Exhaust Brake (Manual Trans) - Manual (Page 10)

10 |
9 6 9 8 2 v . 5 . 0
35.
Re-attach the factory 90-degree
elbow to the outlet of the vacuum
pump/check valve. Secure all connections
with supplied spring band clamps.
36.
Use the remaining length of
blue silicone hose to connect the
vacuum supply to the actuator
control valve and actuator. Run a
length of hose from the brass
1 ⁄
4
"
T-fitting up to the factory vacuum
manifold on the firewall and across
the cowl area to the previously
installed actuator control valve.
37.
Attach the vacuum source line to
the port on the valve labeled #1.
From the port labeled #2, run a
length of blue silicone hose to the
exhaust brake actuator. See Figure 10.
38.
Assemble the black vent hose as
shown and attach this line to the port
labeled #3. Run this line behind the
exhaust brake assembly and secure
to a convenient location. Be sure the
bronze filter is facing down so any
collected moisture will be drained.
Secure all vacuum lines with spring
band clamps as shown. See Figure 10.
39.
Secure all vacuum lines under
the hood using the nylon ties
provided. Use care to avoid pinching
the hose closed.
Figure 10