Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Intake- Ram-Air Intake System '07-10 - Manual (Page 6)

6
96457 v.6.0
You are about to install the Banks
Ram-Air Intake System. Read and
follow all steps before working on the
vehicle. Some components from the
stock air intake system will remain
in service. Take care when removing
stock air intake components to not
damage them.
Use the Bill of Materials Chart and
the General Assembly Drawing to
reference component nomenclature
and location. Use caution when
working in the engine compartment.
Make sure the engine has been OFF
for several hours and cool.
1.
Loosen the hose clamp from the
stock intake tube on the turbo intake.
2.
Loosen the stock hose clamp on
the intake air tube to seperate it from
the stock air box cover. See Figure 1.
3.
Separate the stock intake tube
connected to the turbo intake. Remove
the stock intake tube from the engine
and set aside.
4.
Remove the Mass Air Flow (MAF)
sensor connector from stock air box
filter cover.
Note: Be careful not to damage the
connector or the MAF sensor during
this process.
5.
Remove stock air box by lifting the
air box up and out. The bottom of the
stock air box is held in place by rubber
grommets. There may be some slight
resistance when removing the stock
air box.
6.
Next, remove the stock air box
bolts accessible from the top of the
engine compartment as shown. Then
remove the stock air box tray. See
Figure 2.
Note: Keep the previously removed
bolts for reassembly later in the
installation process.
Section 2
RAM-AIR INSTALLATIoN
Figure 1- Seperate Intake Air Tube from Stock Air Box Cover