Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Intake- Ram-Air Intake System '07-10 - Manual (Page 9)

96457 v.6.0
9
12.
Locate the Banks Ram-Air filter
housing cover. Install the air filter
Minder’s rubber grommet into the
Banks Ram-Air filter housing cover.
Once the rubber grommet is installed
flush into the Banks Ram-Air cover,
then the filter Minder can be inserted
into the rubber grommet. Make sure
the air filter Minder is installed flush to
rubber grommet.
13.
Locate the Banks Ram-Air filter
element and the Banks air filter hose
clamp. Loosely fit the filter clamp to
the air filter element.
Note: See Figure 6 to reference the
correct alignment locater groove to the
Banks Ram-Air filter.
14.
After verifying the alignment
between the Banks Ram-Air filter
and the Banks Ram-Air cover, press
fit the two pieces together until an
audible snap is heard. This process will
ensure that a correct seal has been
established.
15.
Tighten the Banks Ram-Air filter
hose clamp to the Banks Ram-Air filter
cover.
16.
Place the Banks Ram-Air filter
cover onto the Banks Ram-Air housing.
Align and loosely fit the cover onto the
housing.
17.
Install, but do not tighten, the
Banks bellows hose and hose clamp
onto the Banks Ram-Air housing cover.
18.
Locate the Banks turbo intake
hose, tube, and hose clamps from your
Banks Ram-Air kit. Loosely assemble
the Banks intake hose to the Banks
intake tube with the supplied hose
clamps. Attach the turbo intake hose
to the turbo intake tube. Leave the
hose clamps loose.
Figure 5- Remove Stock Air Filter Minder & Air Filter Minder Gasket