Banks Power Chevy_GMC Trucks: Gas ’99 - 14 4.3,4.8,5.3,6.0,6.2,8.1 Intake- Ram-Air Intake System '09-11 Chevy-GMC (4.8L, 5.3L, 6.0L, 6.2L) Pickups & SUV - Manual (Page 10)

10
96883 v.1.0
CAUtIoN: Do Not toUCh oR
ALLow ANy SoLVeNtS to eNteR
the SeNSING eLeMeNt oR
DAMAGe MAy ReSULt.
13.
Locate the supplied Banks MAF
sensor gasket and Install Banks gasket
on the MAF sensor. Make sure the
sensor is properly installed. Install the
MAF sensor (with the additional Banks
Gasket) onto the Ram-Air Cover sensor
boss. See figure 6.
14.
Locate the Banks Ram-Air Intake
tube and supplied throttle body seal
gasket with hose clamp. Slide rubber
grommet and hose clamp over the
outlet of the intake tube.
15.
Install the Banks Ram-Air Intake
tube onto the throttle body. Do not
tighten the clamp at this time.
16.
Locate the supplied PCV hose and
spring band clamp. Slide the spring
band clamp over the PCV hose and
install the PCV hose over the PCV
outlet on the Banks Intake tube. Slide
the clamp to secure the hose to the
PCV outlet on the Banks Intake Tube.
Install the outlet of the Banks PCV
hose into the Valve Cover. See
figure 7.
17.
Align the intake tube to the cover
outlet. See figure 8.
18.
Install, but do not tighten, the
Banks bellows hose and hose clamp
onto the cover and intake tube inlet.
Make sure that the bellow hose is
inserted properly into the cover outlet
and the Banks intake tube and tighten
the hose clamps.
Figure 7