Banks Power Chevy_GMC Trucks: Gas ’99 - 14 4.3,4.8,5.3,6.0,6.2,8.1 Intake- Ram-Air Intake System '09-11 Chevy-GMC (4.8L, 5.3L, 6.0L, 6.2L) Pickups & SUV User Manual
Page 9
96883 v.1.0
9
6.
Next, remove the stock air box tray.
Remove the bolts accessible from the
top of the engine compartment as
shown then remove the stock air box
tray. See figure 4 . Keep the previously
removed bolts for reassembly later in the
installation process.
7.
Locate your Banks Ram-Air Filter
Housing from you kit. Align the Banks
Ram-Air Filter Housing to fit parallel
to fender edge. Install and tighten the
previously removed bolts to secure the
Banks Ram-Air Filter Housing.
Note: It may be necessary to adjust
the radiator to overflow bottle hose to
provide clearance for the Banks Filter
Cover Housing. Adjust any other wires
or hose as needed.
8.
Locate the Banks Ram-Air Filter
Housing cover.
9.
Locate the Banks Ram-Air Filter
Element and filter hose clamp. Install
the filter hose clamp on the filter.
10.
Install the Banks Filter onto the
Banks Ram-Air Filter cover. Press
fit the two pieces together until an
audible snap is heard. This process will
ensure that a correct seal has been
established. Tighten Banks Filter hose
clamp.
Note: see Figure 5 to reference the
correct alignment groove to the Banks
Ram-Air filter.
11.
Place the Banks Ram-Air filter
cover onto the Banks Ram-Air housing.
Align and loosely fit the cover onto the
housing using the supplied fasteners.
12.
From the stock air box, remove
the MAF sensor by loosening the two
(2) torx screws. Leave the factory
gasket on the MAF sensor in place.
Figure 6