Banks Power Jeep Trucks: (Gas ’91 - 02 2.5L) Exhaust- TorqueTube system '91-02 2.5L Wrangler - Manual (Page 3)

TorqueTube Installation
Procedure
NOTE: Do not wrap TorqueTube.
Wrapping the TorqueTube with exhaust
wrap or thermo tape will void the
TorqueTube warranty. Exhaust Wrapping
can cause the TorqueTube to crack and
rust. The TorqueTube has been designed
to operate efficiently and protect the
engine components with out the use of
wrapping.
1.
Remove the air inlet tube and
resonator from the throttle body and
move it aside. On some models, the air
box assembly may need to be
removed in order to relocate the air
inlet tube (See
Figure 1).
2.
On the intake manifold assembly,
remove the throttle cable,
transmission pressure cable and cruise
control cable (if equipped) located
inside the engine compartment.
3.
Disconnect any electrical
connectors and vacuum lines on the
intake manifold and throttle body. Be
sure to label the lines to ensure
correct replacement.
4.
Remove the main injector harness
from the cylinder head.
5.
Disconnect the vacuum harness
and vacuum brake booster from the
intake manifold under the throttle
body.
6.
Loosen belt tensioner and remove
the power steering belt. Next,
disconnect the power-steering pump
and bracket from the intake manifold.
The hex screw on the front pulley may
be rotated to align the pulley with the
screws.
Figure 1
96437 v.3.0
3