Banks Power Ford Trucks: (Gas ’87 - 97 7.5L EFI) Powertrain- TransCommand For E40D_4R100 transmissions - Manual (Page 6)

general insTallaTion PraCTiCes
1.
For ease of installation of your banks
Transcommand ® , familiarize yourself with the
procedure by reading the entire manual before starting
work.
2.
The exploded views provide only general
guidance. Refer to each step and section
diagram in this manual for proper instruction.
3.
Throughout this manual, the driver’s side of the
vehicle refers to the left side, and the passenger’s
side to the right side.
4.
during installation of the Transcommand, be
sure that the ignition key is in the off position.
5.
Route and tie wires and hoses a minimum of 6
inches away from exhaust heat, moving parts
and sharp edges. clearance of 8 inches or more is
recommended where possible.
6.
When raising the vehicle, support it on properly
weight-rated safety stands, ramps or a
commercial hoist. follow the manufacturer’s safety
precautions. Take care to balance the vehicle to
prevent it from slipping or falling. When using ramps,
be sure the front wheels are centered squarely on the
topsides; put the transmission in park; set the hand
brake; and place blocks behind the rear wheels.
CAUTION! Do not use floor jacks to support the
vehicle while working under it. Do not raise the
vehicle onto concrete blocks, masonry or any other
item not intended specifically for this use.
7.
during installation, keep the work area clean. If
foreign debris is transferred to any Banks
component, clean it thoroughly before installing.
6 p.n. 96370
fIguRe 1
do noT mounT
on Framerail