Banks Power Ford Trucks: (Gas ’87 - 97 7.5L EFI) Powertrain- TransCommand For E40D_4R100 transmissions - Manual (Page 8)

8 p.n. 96370
FRONT VIEW
1995 & LATER
FRONT VIEW
1994 & EARLIER
NOTE:
PINS 1-6 ARE CLOSEST
TO TRANSMISSION.
PINS 6, 9 & 10 ARE EMPTY.
a. Insert the red wire with the female socket into pin 1
location of the connector. The locking tang should click
into place when the female socket is fully seated.
b. Insert the brown wire with the female socket into
pin 11.
C. Insert the yellow wire with the female socket into pin
12.
Reinstall the red plastic wedge or retainer
(removed in step 6) between the two rows of
socket pins in the connector body.
Locate the supplied round four pin connector
shell pictured in Figure 5. Remove the red
wedge from front of the connector. using Figures
3 and 5 as a guide, insert the three wires that were
removed from the transmission connector in steps 6
through 8 into the back of the connector shell. Be sure
to refer to the wire colors that were noted on Figure 3.
a. Insert the wire that was removed from pin no. 1
into the pin no. 1 hole of the shell shown in Figure 5.
Be sure pin clicks into place.
b. Insert the wire from pin no. 11 into the pin no. 2
hole.
C. Insert the wire from pin no. 12 into the pin no. 3
hole.
11.
10.
fIguRe 3
FIgURE 4