Banks Power Chevy_GMC Trucks: Diesel ’93 - 96 6.5L Power Systems- Stinger System '94-96 2wd & '94-95 4wd (w_ cat) Suburbans w_ factory turbo option - Manual (Page 6)

where the extension pipe will stop to the end of the
intermediate pipe. Add 2
3 ⁄
4
" to the measurement to compensate
for the slip joint on the extension pipe. Cut the extension to this
length (Crew cab applications may not need trimming). Install
the trimmed pipe onto the intermediate pipe and into the
muffler. Install the 3" hanger clamp into the rubber hanger on
the frame and lightly clamp it to the extension pipe.
Adjust the turbine outlet pipe and exhaust system to provide
maximum clearance to frame and other components. Check
alignment of muffler and tailpipe to hangers and vehicle.
muffler should be straight and level, and the rubber hangers
should be swung or angled towards the front of the vehicle
3 ⁄
4
"
to 1" to allow for expansion of the pipes. When alignment and
clearances look good, tighten all clamps including the factory v-
band on the turbine outlet pipe.
Remove pipe plug and install the pyrometer gauge
probe (supplied in pyrometer gauge kit) in the bung
on the turbo exhaust outlet pipe. We suggest using an anti-
sieze compound on the probe threads to make removal
easier for any future service.
Install instrument gauge panel in a location
providing easy viewing for the driver.
NOTE: An
optional two-gauge console is available from Banks for
mounting gauges on top of the dash.
Wire and plumb gauges as shown in instructions
included with gauges. Route and tie wiring and
nylon hose away from moving parts and hot exhaust
components with cable ties provided.
Reinstall air cleaner assembly on right inner fender
panel. Reinstall vent hose, tighten hose clamps.
Install new air filter supplied. See air filter
cleaning and maintenance instructions elsewhere
in this booklet.
15.
14.
13.
12.
11.
FIGURE 2
6 P.N. 96312