Banks Power Chevy_GMC Trucks: Diesel ’93 - 96 6.5L Power Systems- Stinger System '94-96 2wd & '94-95 4wd (w_ cat) Suburbans w_ factory turbo option - Manual (Page 7)

OTTOMIND INSTALLATION
In order to access the vehicle’s Powertrain Control
Module (PCM), the inner panel of the glove box
must be removed. Open the glove box and remove the
contents. Disconnect the nylon cables from the side of
the compartment, allowing the door to swing down out of
the way.
1994 models- Use a small screwdriver to pry the white
plastic cover from over the compartment light.
Carefully flex the top sides of the compartment toward the
center, allowing the inner glove box to be removed.
Look through the glove compartment opening
toward the right to locate the PCM. The PCM is
held in place by two spring clips. Grasp the PCM and pull
towards the rear of the vehicle. C
CA AU UTTIIO ON N!! D DO O N NO OTT
PPU ULLLL O ON N TTH HEE C CO ON NN NEEC CTTO ORRS S O ORR TTH HEE W WIIRREES S TTH HA ATT A ARREE
H HO OO OK KEED D TTO O TTH HEE PPC CM M.. Pull the PCM out of the dash
with the harness connectors intact, just enough so that you
can remove the access cover.
Remove the Torx screw and the access cover.
Position the PCM so the PROM access hole is
viewed at the bottom left-hand side of the PCM. In this
position, the electrical connectors will be pointing away
from you. The factory PROM is secured to the circuit
board by a blue plastic cover. Using two fingers to
squeeze the locking tabs inward, lift the factory PROM
from the circuit board.
The Banks Ottomind PROM is keyed such that it will
only install one way. With the PCM positioned as
mentioned in the previous step, the Banks Ottomind will
install with the label reading properly. Install the Banks
Ottomind in the socket left vacant by the factory prom.
D
DO O N NO OTT FFO ORRC CEE TTH HEE IIN NS STTA ALLLLA ATTIIO ON N.. If the Ottomind
does not engage the pins with a slight downward pressure,
recheck the orientation of the Ottomind. If difficulty
persists, check to that there are no bent or broken pins on
the circuit board.
Once the Ottomind is installed in the PCM,
reconnect the vehicles batteries, and start the
vehicle. Check to ensure that the Service Engine Soon and
the Service Throttle Soon lights go out shortly after the
vehicle is started. If the vehicle starts and runs without any
difficulty, reinstall the access cover, the PCM and the glove
box panel.
Start engine, allow engine to warm up. Drive vehicle,
listen for exhaust leaks or rattles. Reposition or tighten
exhaust components as required.
21.
20.
19.
18.
17.
16.
7 P.N. 96312