Banks Power Ford Motorhomes: (Gas ’93 - 98 7.5L Class-A) PowerPack System (Class-A, JD_OK chassis) For Use w_ 460 EFI Engine - Manual (Page 10)

figure 9
rain water not eliminated by the scoop’s water
drain hole from climbing up into the air filter. The
curved outlet section of the super-scoop may be
trimmed back if less bend is required to make a
more streamlined hose routing. See Figure 7 .
once a location has been determined for
the super-scoop, mount it using one of the
methods outlined below.
the banks super-scoop may be mounted by several
means. If the grille consists of horizontal bars or a
perforated metal screen heavy enough to support
the inductor, it may be secured using four 14”
nylon cable ties, provided, slipped through the ears
on the scoop and through the grille. See Figure 8.
an alternate method is to mount the inductor
using the four perforated metal straps provided.
these can be bent as required and attached to
the scoop’s ears with the 1 ⁄
4
20 x 1 1 ⁄
4
hex bolts,
1 ⁄
4
-20 nylock nuts and 3 ⁄
4
O.d. x 5 ⁄
16
I.d. flat washers
provided. The opposite end of the straps may be
attached to any convenient mounting points such
as the gravel pan, grille brackets, etc. as required,
with four no. 10 x 3 ⁄
4
” sheet metal screws provided.
a combination of cable ties and scraps may also be
used.
connect the fresh air inlet on the air filter housing
to the super-scoop using the 4” diameter flex hose
provided. cut the hose to the desired length using
a knife and diagonal cutting pliers. secure with no.
64 hose clamps.
check over the entire installation for loose
clamps or bolts, hoses and wiring too close
to hot or moving parts, sharp edges, etc. , and
correct as necessary.
reconnect battery cables. reinstall engine
“dog house” cover.
start engine and listen for any exhaust leaks.
tighten bolts or clamps to correct leaks as
required. allow engine to warm up and test drive
vehicle. NOTE: Exhaust tubing will smoke for the
first 15-20 minutes of operation. This is normal, as
grease used in the bending process will burn off
the inside of the pipes.
three banks powerpack plaques have been
included in your kit. These may be affixed
to your vehicle by pealing off the backing and
pressing firmly in the desired location. a piece of
masking tape applied to the vehicle with reference
measurements to other emblems or body trim may
be used to level and locate your plaques.
Figure 9
shows suggested locations for plaques.
39.
38.
37.
36. 35.
10 p.n. 96347