Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- SpeedBrake '06-07 (PDA) For use with PowerPDA - Manual (Page 18)

18
97227 v.7.0
6-pin connector and connect the five (5)
wire 6-pin male connector to the Diesel
tuner female 6-pin connector.
7.
For the cleanest PowerPDA
installation (figure 15), remove the
fuse access panel by pulling it out
from the side of the dash. Route the
RJ12 connector (phone like connector)
on the Banks OBD II Interface cable
under the dash and out where the
fuse access panel was. The RJ12
connectors’s cable can be slid under
the door frame’s seal and run up to
the top of the dash. Plug the RJ12
connector into one of the receptacles
in the base of the PDA docking station.
Re-install the fuse access panel.
8.
Your Docking Station is now
installed and is ready for the
Banks PowerPDA. Install the Banks
PowerPDA into the Docking Station.
Be sure the Banks PowerPDA is
completely seated in the Docking
Station against the lower support
bracket.
Note: there may be a snug fit
when installing the PowerPDA
into the docking station. Do not
apply excessive force during PDA
installation.
9.
Plug the docking station’s charging
cable (seen in figure 14) into the
charging receptacle on the lower edge
of the PowerPDA.
Figure 17