Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- SpeedBrake '06-07 (PDA) For use with PowerPDA User Manual
Page 9
97227 v.7.0
9
6.
Secure the wire harness using
some of the supplied cable ties along
the factory wire harness up the left
side of the engine to the Fuse box.
7.
Remove the Driver side cowl
support Brace and retain hardware for
reuse. See figure 3.
8.
Remove the fuse box cover to
access the fuses on the electrical
center and set aside.
9.
Remove the fuse box assembly
cover by expanding the fuse box out
towards the engine side and lifting up,
exposing the fuse electrical center.
See figure 4.
10.
Push out on the tab closest to
the fender and the two locking tabs
on the side of the electrical center
and lift up to gain access to the C100
connector. Disconnect the c100
connector. See figure 5.
11.
Install the ground ring terminal
on the SpeedBrake wire harness onto
the bolt on the bottom of the electrical
center closest to the fire wall. See
figure 5.
12.
Insert the male c100 connector
on the SpeedBrake wire harness to the
female C100 factory connector. Insert
the female c100 connector on the
SpeedBrake wire harness to the male
C100 factory connector.
Figure 5