Banks Power Ford Trucks: (Gas ’04 - 08 F-150 V6 & V8) Exhaust- Monster Exhaust, '04-08 F-150_Mark-LT 4.2L, 4.6L & 5.4L New Body Style (Non-Heritage models) User Manual
Page 10
10
96319 v.6.0
NOTE: Install the rubber hanger pins to
the vehicle frame if previously removed.
16.
Reinstall the two (2) factory
M8x1.25 bolts through the rubber
hanger into the vehicle frame. See
Figure 2.
17.
Install the supplied 3.5” band
clamp over the inlet of the Monster
tip. Install the tip onto the rear tailpipe.
Loosely tighten the band clamp to
secure the Monster Tip to the rear
tailpipe.
18.
Adjust the tip about
1
⁄
2
”-1” under
the body panel, such that the position
is aesthetically pleasing.
19.
With the exhaust positioned
properly, begin to tighten the clamps
and hardware starting with the ones
closest to the front of the vehicle and
working your way back. Torque the
exhaust clamps evenly to 35 ft-lbs.
Make sure that each slip is fully
inserted (+/-
1
⁄
4
”). Torque the factory
M8 hardware to 22 ft-lbs.
20.
Remove the protective covering
from the tailpipe tip.
CauTIoN: The protective covering
may ignite and burn if not removed
prior to running the engine.
21.
Your system includes two (2)
“Banks Power” logos designed to
complement the Ford emblems on
the vehicles front fenders. Use the
provided measurements for a clean
factory look. See Figure 7.
22.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended. The Banks Monster
Exhaust installation is now complete.