Banks Power Ford Trucks: (Gas ’04 - 08 F-150 V6 & V8) Exhaust- Monster Exhaust, '04-08 F-150_Mark-LT 4.2L, 4.6L & 5.4L New Body Style (Non-Heritage models) User Manual
Page 9
96319 v.6.0
9
12.
For ECLB Only. Install the 3”
hanger clamp onto the Intermediate
Extension Pipe. Install a 3” clamp onto
the muffler inlet. Install the Banks
Muffler inlet onto the Intermediate
Extension Pipe outlet. Loosely tighten
the 3” clamp to secure the Banks
Muffler. Insert the hanger into to
factory rubber hanger.Skip to step 14.
13.
For ECSB & SCMB Only. Install
a 3” clamp onto the muffler inlet.
Install the Banks Muffler inlet onto
the intermediate pipe outlet. (Note the
inlet labeling of the muffler) onto the
intermediate pipe and lightly tighten the
3” clamp.
14.
Install a 3” clamp on the Banks
Muffler outlet. From the vehicle rear,
route the Front Tailpipe over the rear
axle. Start the Front Tailpipe hanger
pin into the corresponding vehicle
rubber hanger. Install the Front
Tailpipe into the Banks Muffler Outlet
(see Figure 6). Loosely tighten the 3”
clamp to secure the Front Tailpipe.
15.
Install a 3.5” clamp on the Front
Tailpipe outlet. Start the Rear tailpipe
hanger pin into the corresponding
vehicle rubber hanger. Install the Rear
Tailpipe into the Front Tailpipe outlet.
Loosely tighten the 3.5” clamp to
secure the Rear Tailpipe.
Figure 6