Banks Power Toyota Trucks: (Gas ’07 - 14 5.7L Tundra) Exhaust- Monster Exhaust, Split-Dual out the back '07-08 - Manual (Page 10)

10
97231 v.6.0
19.
Be sure that the two (2) tailpipes
are completely engaged into the
Y-pipe. Adjust your tailpipes so that
the tips are symmetrical and 1” below
the rear bumper. The hanger pins
should be parallel with the frame-
mounted pin and the rear rubber
hangers are all slightly positioned
forward.
NOTE: Recommended distance between
exhaust tip and body is half (1/2”) inch to
one (1”) inch.
20.
Beginning with the clamps
closest to the catalytic converters,
and working your way back, align the
saddle clamps to the radius of the
corresponding pipe slots. Torque the
nuts on each of the exhaust clamps to
35 ft-lb.
21.
Remove the protective covering
from the tailpipe tips.
Caution: the protective covering
may ignite and burn if not
removed prior to running the
engine.
Figure 7