Banks Power Toyota Trucks: (Gas ’07 - 14 5.7L Tundra) Exhaust- Monster Exhaust, Split-Dual out the back '07-08 - Manual (Page 8)

NOTE: All clamps should be positioned
at the beginning of the slots (on the 1⁄2
circle punch) and evenly tightened. See
Figure 4.
11.
Install the 3” hanger clamp onto
the Banks Muffler outlet such that
the hanger pin is facing forward.
Install the clamp hanger pin into the
corresponding vehicle rubber insulator.
See Figure 3.
12.
Install the Banks rear Y-pipe into
the muffler outlet such that the outlets
are pointing up. Install clamps onto
each Y-pipe outlet.
13.
Install the Banks hanger brackets
onto the rear of the frame rail. Be sure
the hanger pin is align parallel to the
frame rail and torque the hardware to
48ft-lb. See Figure 5.
14.
Install the supplied rubber
insulators onto the Banks hanger
brackets.
15.
Install the driver-side tailpipe onto
the left Y-pipe outlet. install the driver-
side tailpipe hanger into the vehicle
rubber insulator. See Figure 6.
16.
Install the passenger-side tailpipe
onto the right Y-pipe outlet. install the
passenger-side tailpipe hanger into the
vehicle rubber insulator. See Figure 6.
17.
Move the spare-tire to the rear
of the vehicle and center between the
dual tailpipes. tighten the spare tire
with the manufacture tire tool so that
it is retained into place (see Figure 7).
18.
Install the 3” Band clamp onto the
outlet of the left tailpipe and install the
left tailpipe tip onto the left tailpipe.
Keep the wrapping on until installation
is complete. The tip and the clamp
should be rotated so the clamp nut
and drain hole are pointing down.
Repeat this process for the right side
tailpipe tip installation.
Figure 4
8
97231 v.6.0