Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Intake- Ram-Air Super-Scoop 5.9L ('03-07) & 6.7L ('07-08) - Manual (Page 11)

96536 v.8.0
11
6.
Lift up, align and fit the Banks
Super-Scoop into position as far into
the bottom of the Ram-Air housing
down spout as possible. Using the two
(2) holes on top of the Super-Scoop as
a template, mark the Banks Ram-Air
housing with a marker. See Figure 7.
7.
Remove the Banks Ram-Air housing
(reference Banks Ram-Air installation
manual for removal). center punch the
location of the two (2) holes marked
in the previous step then drill using a
step drill to 5⁄16 ”.
Note: Make sure the center of the
holes are between 3⁄8 ”- 1⁄2 ” from
the bottom edge of the housing. See
Figure 8.
8.
clean the holes and install the
supplied clip-on-nuts over the holes.
Install the clip-on-nut so that the nut is
on the inside of the Ram-Air housing.
See Figure 8.
9.
Re-install the Ram-Air housing
following Banks Ram-Air installation
manual. Make sure the Super-Scoop
opening is over the bottom of the
Bank’s Ram-Air housing down spout.
Lift the Super-Scoop into place and
install the supplied 1⁄4 ” bolts and
washers through the Super-Scoop
holes attaching to the clip-on-nuts on
the Ram-Air Housing. Hand tighten the
bolts. See Figure 9.
10.
Adjust the inlet of the Super-
Scoop to fit the contour of the lower
bumper.
Figure 7 Mark locations of holes on Ram-Air Housing.