Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Intake- Ram-Air Super-Scoop 5.9L ('03-07) & 6.7L ('07-08) - Manual (Page 8)

8
96536 v.8.0
NOTE: Before installing the Banks
Super-Scoop make sure to have a
completely installed Banks Ram-Air
Intake System in your vehicle.
1.
Remove all Fasteners or plastic
retainers attached to the fender lining
then remove the wheel liner and set
aside. See Figure 2
Note: Detach any wire harness clips
from the fender well liner and secure
them out of the way.
2.
Locate supplied brackets and Banks
Super-Scoop. Place the brackets on top
of the Super-Scoop inlet over the slots.
Note the location and direction of the
bracket in Figure 3.
Note: For standard bumper vehicles
position the brackets over the larger
slot on the Super-Scoop inlet. See
Figure 3.
3.
Locate the supplied 20mm push-
in retainers and insert them from the
inside of the Super-Scoop opening
through the slots securing the brackets
to the Super-Scoop. Push in the
retaining pin to expand the retainer
and fasten the Super-Scoop to the
brackets. See Figure 4.
4.
From under the vehicle on the
passenger side locate the two (2)
factory nuts attaching the bumper
to the bumper support bracket, see
Figure 5. Loosen and Remove the
nuts, retain for reuse.
5.
Install the Banks Super-Scoop
from beneath the front bumper and
place the Super-Scoop’s opening over
the bottom of the Banks Ram-Air
housing down spout. If the bottom of
the Banks air housing is sealed, see
pages 8-9 of the Banks Ram-Air Intake
Installation Manual. Insert the brackets
over the frame bolts as shown in
Figure 6. Re-install the factory nuts
onto the factory bolts. Hand tighten
the nuts at this time.
Section 2
SuPeR-SCooP INSTALLATIoN
Figure 2 Removal of the passenger side wheel liner.