Monster exhaust system installation – Banks Power Toyota Trucks: (Gas ’07 - 14 5.7L Tundra) Exhaust- Monster Exhaust, Split-Dual out the back '09-10 User Manual
Page 6
6
97251 v.1.0
Monster Exhaust System Installation
1.
Disconnect the negative (ground)
cable from the battery (if there is more
than one battery, disconnect both
negative cables). Secure the cable so
it cannot accidentally come in contact
with the post.
2.
Raise the vehicle and support it
securely with properly weight-rated
safety stands, ramps or a commercial
hoist. Take care to balance the vehicle
to prevent it from slipping or falling.
When using ramps, be sure the wheels
are centered squarely on the topsides.
Place the transmission in park
(automatic), set the parking brake and
securely block the wheels that are on
the ground.
CAUTION: DO NOT WORK UNDER
ANY VEHICLE SUPPORTED ONLY
BY A JACK. SEVERE INJURY MAY
RESULT.
3.
From under the vehicle remove the
factory exhaust bolts located on both
flanged Y-Pipes. Keep the removed
bolts. They will be reused in a later
step.
Note: Remove the factory gaskets.
the exhaust system will be hanging by
the hanger clamps.
4.
Liberally apply an aerosol lubricant
on all the hanger pins. Remove the
exhaust system from the vehicle by
removing each hanger pin from the
rubber insulator.
Note: Remove pins from front of
vehicle to rear.
5.
Drop the exhaust system to the
floor and move out of the way. You
will not be reusing any components
from the exhaust system.
Figure 1