Banks Power Toyota Trucks: (Gas ’07 - 14 5.7L Tundra) Exhaust- Monster Exhaust, Split-Dual out the back '09-10 - Manual (Page 7)

97251 v.1.0
7
WARNING! The following steps
may require the use of a torch
and/or saw. Proper safety
equipment should be used.
Failure to use proper safety
equipment may result in severe
injury.
6.
Measure 16- 1 /
4
” from the left flange
connection forward following the
right side of the pipe and marking the
location on the left factory intermediate
pipe as shown in Figure 1.
7.
cut the pipe using a hacksaw or
similar electric cutting tool at the mark
location. Take time when measuring
and cutting the factory outlet pipe
to ensure the proper location and a
straight cut. Improper cut will result
in poor fitment of the Banks Monster
exhaust system.
8.
Install a 2- 1 /
2
” clamp on the left
factory intermediate pipe outlet.
Install the Banks Y-pipe flange
connection and supplied ring gasket
onto the factory intermediate pipe
flange connection and then insert the
Y-pipe slip joint over the left factory
intermediate pipe. Lightly tighten the
2- 1 /
2
” clamp over the Y-pipe left inlet
and re-use the factory hardware to
tighten the factory flange connection
to the Y-pipe flange.
9.
Locate the supplied intermediate
pipe and cut the intermediate pipe
19” from the NON-swedged end of the
intermediate pipe. See Figure 2.
10.
Locate and install the
intermediate pipe swedged end onto
the Banks Y-pipe outlet. Install a 3”
saddle clamp onto the swedged end
and loosely tighten. Slide on the sliding
hanger clamp onto the intermediate
pipe such that the hanger pins face the
rear of the vehicle. Install the clamp
hanger pins into the corresponding
vehicle rubber insulators and loosely
tighten the clamp.
Note: When installing hanger pins into
rubber insulators make sure that the
pin is pushed properly into place. See
Figure 3.
11.
Install the 3” exhaust clamp onto
the inlet of the Banks Monster Muffler
(Note: the inlet labeling of the muffler).
Orient the “Monster” logo such that
it is parallel with the frame rail. Install
the Banks Muffler inlet onto the
intermediate pipe and lightly tighten
the 3” clamp.
Figure 2
19”
Cut line