Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Exhaust- TorqueTube system 4.0L I-6 ('91-99 Wrangler_'91-99 Cherokee_'93-98 Grand Cherokee_'91-92 Comanche) - Manual (Page 5)

96433 v.5.0
5
9.
Remove the intake manifold
from the engine block. Remove the
remaining bolts (bolts 3,6 and 7) and
remove the exhaust manifold.
10.
Inspect the exhaust and intake
mounting surfaces of the cylinder
head and remove any rust or carbon
that might prevent the TorqueTube
or intake manifold from sealing. Be
careful debris does not enter the
engine ports.
11.
Install the supplied gasket onto
the cylinder head dowels. Place a
small amount of anti-seize on the
threads of each of the eleven (11)
factory intake and exhaust bolts.
12.
Install Banks TorqueTube
manifold onto the cylinder head and
support with loosely installed bolts in
locations
3,6 and 7.
Figure 2
Figure 3