Banks Power Nissan Trucks: (Gas ’04 - 11 5.6L Titan) Intake- Ram Air Intake System '04-09 (Nissan Titan) '04-08 (Nissan Armada 5.6L, 04-08 Infiniti QX56 5.6L) - Manual (Page 13)

96498 v.3.0
13
15.
Locate the Banks filter cover.
Install the Banks filter onto the Banks
filter cover. Tighten Banks filter hose
clamp. See Figure 9.
16.
Insert Banks filter cover onto the
Banks air housing. Locate supplied
5 ⁄
16
-18 screws and fasten the cover
to the housing. Note: make sure the
Banks cover is lined up correctly. See
Figure 10.
17.
Install the supplied bellows hose
clamps to the bellows.
18.
Connect the bellows to the Banks
Ram-Air intake tube. Make sure the clamp
on the bellows is loose enough to allow
the Banks Ram-Air intake tube to fit. Insert
the bellows into it to the Banks Ram-Air
intake tube.
Note: Be sure to line up the notch on the
Banks Ram-Air intake tube with the notch
cut out on the bellows. See Figure 11.
19.
Remove a grommet from the
stock air filter housing by pulling it
off from the outside of the stock air
filter housing. Install grommet to the
bottom of the Banks air filter housing.
See Figure 12.
Note: Be sure to insert the grommet
so that the larger side of the grommet
is outside the Banks air filter housing
and be sure that the grommet is
securely in place.
20.
Install the Banks air filter housing
into vehicle. Insert the Banks snorkel into
the air intake opening first. See Figure
13. Slide the Banks air filter housing into
the vehicle and insert the grommet onto
the Banks air filter housing screw that was
installed in Step 13.
Note: Be sure the grommet on the Banks
Housing is securely attached to the Banks
air filter housing screw that was installled
in Step 13.
21.
connect the other end of the bellows
that is not attached to the Banks Ram-Air
intake tube to the Banks air filter housing.
Loosen hose clamp on the bellow enough
to allow the air filter housing to slide in,
then tighten hose clamp once Banks air
filter housing is inserted.
22.
connect the Banks Ram-Air intake
tube to the throttle body and tighten the
two hose clamps that connect the Banks
Ram-Air intake tube to the throttle body.
23.
Reinstall the MAF connector to MAF
sensor located on the Banks Ram-Air
intake tube.
24.
Install the PCV vent hose connections
to the Banks Ram-Air intake tube. Secure
the connections by using stock spring
clamps.
25.
Reinstall the engine cover by
inserting the feet of the engine cover into
the rubber grommets and pressing them
in. Then locate the screws from step 1
and reinstall them using the 10mm socket
wrench to secure the engine cover in
place.
26.
You have successfully completed the
installation of the Banks Ram-Air Intake
system. Make sure to go over all hose
clamps for tightness and connectors for a
sure fit. Make sure that the intake tube is
not touching any engine components.
-eND, SeCTION 2-