Banks Power Nissan Trucks: (Gas ’04 - 11 5.6L Titan) Intake- Ram Air Intake System '04-09 (Nissan Titan) '04-08 (Nissan Armada 5.6L, 04-08 Infiniti QX56 5.6L) - Manual (Page 8)

8
96498 v.3.0
7.
Remove the MAF sensor and the
stock MAF sensor gasket located
on the air filter housing by using the
phillips screwdriver and set the sensor
aside.
Note: Take care when handling the
MAF sensor.
8.
Locate the supplied MAF sensor
gasket from your Banks kit and install
the gasket on the MAF sensor.
Note: Make sure to remove the stock
gasket from the MAF sensor before
installing the Banks gasket. Make sure
the supplied MAF sensor gasket is
aligned as shown in Figure 6.
10.
Using the supplied screws, lightly
tighten the MAF sensor to the Banks
Ram-Air intake tube.
11.
Remove the stock air filter
element from the stock air filter
housing.
12.
Remove the bottom of the stock
air filter housing by removing the two
screws shown in Figure 7. Pull the
housing straight up from the corner
that is closest to the driver side head
light.
Note: When removing the air filter
housing from the grommet, there will
be slight resistance.
For 4WD Vehicles Only:
Remove the front differential breather
hose from the air intake housing (See
Figure 8) and secure it.
13.
Remove a screw and washer that
was detached from the grommet in
step 12 and install them in the hole
that held screw #2 from Figure 7 in
place.
14.
Locate the supplied filter hose
clamp and install onto the Banks filter.
Figure 5- Removal of Air Filter Housing (Top)