Figure 4 figure 5 – Banks Power Ford Motorhomes: (Gas ’93 - 98 7.5L Class-A) PowerPack System (Class-A, Ford chassis, w_ cat.) For Use w_ 460 EFI Engine User Manual
Page 8
8
p.n. 96351
26.
install a 2
1
⁄
2
x 3” stainless steel adapter onto the
catalytic converter outlet. not the orientation of
the notch on the adapter and corresponding button on
the converter. drive the adapter onto the converter
until the button bottoms in the notch.
NOTE: If the button is missing, measure and mark the
converter 1
11
⁄
16
” in from the end, and drive the adapter
onto the converter until it reaches this mark.
when the adapter is in place, install the original
2
1
⁄
2
” exhaust u-clamp to secure the adapter.
See Figure
6
.
install a 3 x 28” extension pipe onto the 2
1
⁄
2
x 3”
adapter. tighten a 3” u-clamp to secure the extension
pipe to the converter adapter.
NOTE: Some extension pipes are supplied with
a heat shield welded to the extension. Install
the extension with the heat shield toward the
vehicle floor to protect the floor from heat.
install a 3” u-clamp with hanger rod into the existing
rubber hanger located between the catalytic converter
and muffler. See Figure
6
.
27.
28.
figure 4
figure 5