Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit, F-450_F-550 '03-07 Cab & Chassis - Manual (Page 10)

14.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front and working your way back.
Torque the exhaust clamps evenly to
35 ft-lbs. Make sure that each slip is
fully inserted (+/- 1 ⁄
4
inch) and that
all mount hangers are in the forward
position (see Figure 4). Torque V-band
clamp on the T.O.P. to 7 ft-lb.
15.
Your system includes two “Banks
Power” logos designed to complement
the Ford badging on your truck. Use
the provided measurements (see
Figure 5) to position the logos for a
clean factory look.
16.
Re-connect negative battery
cable(s). Start the engine and listen
for exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack-welding slip connections
to prevent disengagement is
recommended.
Banks Monster Exhaust installation is
now complete.
Figure 4
10
94441 v.5.0