Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit, F-450_F-550 '03-07 Cab & Chassis User Manual
Page 9
8.
Install the supplied rear
intermediate pipe onto the catalytic
converter outlet. Be sure the notch
and catalytic converter pin are
properly aligned. Lightly snug the 3
1
⁄
2
”
clamp onto the front of the intermediate
pipe / catalytic converter outlet.
9.
Install a 4” clamp onto front the
supplied extension pipe. Install the
supplied extension pipe onto the outlet
of the rear intermediate pipe. Loosely
snug the clamp at the connection.
10.
Install a 4” exhaust clamp onto
the Banks Monster Muffler inlet.
connect the muffler inlet onto the
rear of the extension pipe. Install the
4” muffler clamp onto the Monster
muffler outlet such that the hanger
pins are towards the front of the
vehicle. Install the hanger pins into the
vehicle’s rubber insulators.
11.
Route the tailpipe over the rear
axle housing and into the muffler
outlet. Install the tailpipe hanger pin
into the corresponding rubber hanger.
Loosely snug the 4” clamp onto the
muffler outlet.
12.
For Models with storage
boxes: Adjust the tailpipe turndown
parallel with the ground so that the
bumper or storage boxes do not get in
the path of the exhaust (see Figure 3).
13.
For Models without storage
boxes: Install the 5” Monster tailpipe
tip on the exhaust. Keep the wrapping
on until installation is complete. The
tip should be rotated so the clamp
nut and drain hole are pointing down.
Align the end of the tip with the
body line of the truck. Remove the
protective covering from the tailpipe
tip.
Caution: The protective covering
may ignite and burn if not removed
prior to running the engine.
Figure
3
96441 v.5.0
9