Monster exhaust system installation – Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Exhaust- Monster Exhaust, Single Passenger side exit '07-10 User Manual
Page 4
4
96566 v.3.0
1.
As a precaution, disconnect the
ground of the battery (if there is more
than one battery, disconnect both).
2.
Raise the vehicle and support it
with properly weight rated safety
stands, ramps or a commercial hoist.
Follow the manufacturer’s safety
precautions. Take care to balance the
vehicle to prevent it from slipping or
falling. When using ramps, be sure the
front wheels are centered squarely on
the topsides; place the transmission in
park; set the parking brake and place
blocks behind the rear wheels.
CAUTION: DO NOT WORK UNDER
ANY VEHICLE SUPPORTED ONLY
BY A JACK. SEVERE INJURY MAY
RESULT.
WARNING! The following step may
require the use of a torch and/
or saw. Proper safety equipment
should be used. Failure to use
proper safety equipment may
result in severe injury.
3.
Removal of the factory exhaust
can be simplified by cutting the factory
exhaust pipe behind the muffler. This
will allow the tailpipe to be removed
as a separate piece.
4.
Remove the factory tailpipe from
the vehicle by disengaging the exhaust
system hanger pins from the rubber
hangers using a large screw-driver or
pry bar.
NotE: Lubricating the rubber hangers
with WD-40 or similar lubricant will ease
removal of the hanger pins.
5.
Remove the factory muffler from
the vehicle by removing the three (3)
nuts from the factory exhaust flange
located at the factory muffler inlet.
6.
Install the Banks flanged
intermediate pipe and 3-bolt gasket
onto the headpipe. Loosely assemble
with the supplied bolts, washers, and
nuts.
7.
Slide the supplied 4” exhaust
hanger clamp onto the outlet of the
Banks flanged intermediate pipe. Insert
the hanger pin into the factory rubber
hanger.
Monster Exhaust System Installation
Figure 2